For example, you can scrape off the outer layer of the seed with a little sandpaper, creating micro-abrasions that should let some water in. So you don’t overdo it with this scraping we have a little trick: roll up a piece of very fine sandpaper, with the rough side on the interior, and secure it with tape. Place the seeds inside and cover the openings with your hands. Then just shake it for a couple of minutes and the sandpaper will do its job. Another more risky option is to use a knife to cut the seed transversely, ever so slightly, which will help the water penetrate the shell.
If all else fails, there are still a few more aggressive tricks that should only be used when, after a few days, your seeds have failed to hatch and make their way into the world.
First, you have won half the battle if you were careful with the original storage. Seeds must be kept in a cool, dry place. Therefore, the best option is to store them in refrigerators at a temperature between 6 and 8 degrees Celsius, and with relative humidity levels between 20% and 30%. And sheltered from light, of course.
Other good choices for germination
Another good investment, which can be key in the case of old seeds, is Jiffy 7. This product is a compressed pill of dried peat that you need to soak for a few minutes. At this point it becomes a small sack of soil that is specially designed to facilitate germination, because it features the ideal structure, is sterilized, has all the necessary elements to nourish the seedlings during the first week, and is pH-neutral. Due to these characteristics it can be your best bet to get your older seeds to sprout.
For those beginning with the glass of water, the second step would be to move the seeds, after 24 hours, to the wet paper towels. Germination normally takes between 48 and 72 hours, and, in the case of old seeds, can last up to 5 or 6 days, or even weeks. Therefore, transferring the seeds to wet paper gives you more peace of mind, as you are dealing with less water and, if they open, they will not quickly drown.
Saving cannabis seeds is a widely used method for preserving genetic varieties that one has particularly enjoyed or that worked very well when planted. Therefore, growers often store some seeds for many years.
But you must be careful: the liquid must not be cold, but rather at a temperature of around 22° C. And you must keep the container away from major sources of light. During the 24 hours that the seeds are there you will have to keep a very close eye on them in order to remove them quickly if they open, so they don´t “drown.”
The older a cannabis seed gets, the harder it is to pop. But hard doesn’t mean impossible. If you’ve been saving your seeds for a rainy day and it finally started pouring, these tips could help you get most, if not all, of your old beans to germinate.
The seed’s shell is made up of two pieces, with a seam going all around. The side that’s raised more than the other is the ridge. A hardened ridge can make it difficult for the seed to open. To remove the ridge, run a sharp blade along the ridge on both sides. Handle gently and it should come off without damaging the inside of the seed.
1. PRE-SOAK WITH SUPPLEMENTED WATER
In a life or death situation, surgery may be the only option. Meaning—only do this if nothing else has worked because this technique ruins as many seeds as it saves.
Removing the ridge not only makes it easier for the seed to open, it helps with water absorption.
As you proceed through these steps, the risk of damaging your seeds past the point of recovery increases. Between each suggestion, give them a few days to a week to germinate. Allow the outside to dry each time to prevent rot. Do not try all or multiple techniques at once.
The first step in any farming process is to make sure we have the right seeds, and the same goes for weeds. When harvesting autoflowering marijuana seeds, everything is preserved, and nothing is lost. This means that all types of seeds are ripe and immature. How do we distinguish good seeds from bad ones? You are considering the following.
The second method involves the use of carbonated water with a pH below 7. This slightly acidic solution absorbs the outer layer of the seeds. Put the seeds in a container full of carbonated water and wait for about two hours. The solution loosens the seed coat and allows it to absorb water, which helps germinate.
Sorting Seeds By Color And Shape
To use a mixture of hydrogen peroxide for the germination process, use 1 to 2 drops of 99% hydrogen peroxide in a glass of water. After soaking for 24 hours, the outer shell is softened enough to germinate the seeds.
Method 3 requires that we use a mixture of hydrogen peroxide to soften the seed’s outer skin. It would be best if we were careful when mixing the peroxide solution, as we can burn the seed, and it will never germinate.
Clean and clean water contains oxygen and hydrogen molecules. These are two life-supporting elements necessary for germination. Soaking the seeds for at least 12 hours allows water to enter living cells, a process known as osmosis. Now that the internal conditions promote germination, the semen embryo expands and breaks out of the protective sheath.