Posted on

how to grow a pot plant from a seed

We like to use seedling pellets that are made of a mix of compressed peat moss and coco husk. To expand, soak it in water for 10 minutes. Once your seedling pellet has absorbed enough water and has expanded to its maximum size, drain off any excess water. The growing medium should be like a damp sponge that would not leave streaks on the table. Dig a small hole about 1/4 in deep for your seed. Use a spoon to lift the seed out of its bath. If it has popped out a taproot be careful not to damage it. Gently place the seed into the hole and lightly cover it with dirt from the pellet. Now that you have started the germination process, your seedling will come above ground within two weeks. The older the seed, the longer it takes for it to germinate.

Seedlings require a medium amount of light in which it has enough to grow but not too much light that it gets burned. Leaving your seedling in direct sunlight will cause the leaves to curl, while too little light will cause the seedling to stretch. If growing outside, seedlings want to see a direct light source to stop them stretching. If inside, a sunny windowsill with more than half a day of sunlight works wonders. Otherwise, 18 in away from a growing light works excellently. Your seedling should not stretch more than 6 in at most. We’ll cover lighting in more depth in a later blog.

For young plants, it’s best to use bottled water as it has no chlorine added. If using tap water, let it sit for 24 hours before watering to dissipate any chlorine. Chlorine can also be eliminated by boiling for 20 minutes. Under normal conditions, after soaking your seedling pellet, it should contain all the moisture your plant needs before it comes above ground. As it grows, it will only need about a shot glass worth of water at most per week to keep the medium damp. Seedlings don’t drink a lot of water, which makes sense given their size. Your plant will do better in a growing medium which is damp. Overwatering is just as deadly as drying out.

2) Planting your seed

Our favorite thing about starting from a seed, rather than a clone, is that you get to see the full life cycle and enjoy a plant that is unique, just like you. An entirely new genetic makeup will enter the world for the first time, and if you’re lucky, something remarkable might be born.

Starting from seed is a remarkable journey. Understanding the biology is one thing, but comprehending how a little miracle bean can turn into a gigantic tree that can affect your body and mind is nothing short of an evolutionary miracle. Or rather a co-evolutionary story of plant and human.

Raising a seedling, however, requires some patience, gentle hands, and a smidgen of luck. Thankfully pot seeds are remarkably vigorous because they are what’s called endosperm seeds, which means they have almost pre-formed cotyledon leaves before you even add water. Below is a brief guide on the techniques we have found yield the most success when starting seeds and raising your seedling to a healthy plant ready for transplanting.

To accelerate germination, you are going to want to soak your seed in a small container with lukewarm water and place it in a dark and warm place for 12-24 hours, but no longer. By drenching the seed, it absorbs the water thoroughly, activating the germination process. Doing this also helps to loosen the shell as it becomes a little softer making it easier for the embryo to crack it open. When your seed sinks to the bottom it is ready to be planted, and sometimes the seed will pop out a small taproot. A seed can still be planted though if it does not sink.

Even if your seed sprouts fast and grows vigorously, it still has roughly a 50/50 chance of being female and producing buds, instead of turning out to be a male.

Plants grown from seed can be more hearty as young plants when compared to clones, mainly because seeds have a strong taproot. You can plant seeds directly into an outdoor garden in early spring, even in cool, wet climates.

If you’re ready for a more serious approach, make sure you have the space for a proper garden and pop the seeds to see what fruit they bear.

Time to germinate

One drawback of clones is they need to be taken during the vegetative stage of a plant—flower is too late—so if you have a small setup with only one light, it can be hard to keep clones alive while flowering other plants, because the two need different amounts of light.

If cannabis is legal in your state, you can buy seeds or clones from a local dispensary, or online through various seed banks.

You can also minimize headaches and avoid the hassle of seed germination and sexing plants by starting with clones.

In commercial cannabis production, generally, growers will plant many seeds of one strain and choose the best plant. They will then take clones from that individual plant, which allows for consistent genetics for mass production.